Washing filter A
Wash your filter
Hold the filter under a running tap, until the water runs clear.
Tap the filter to remove excess water.
Squeeze and twist with both hands to make sure the excess water is removed.
Dry your filter
Leave your filter to dry completely, for at least 24 hours in a well-ventilated,
warm place.
Do not dry your filter in a tumble-dryer or near a naked flame.
Important: your filter must be completely dry before you put it back into the
machine. Your machine could be damaged if used with a damp filter.
Refit your filter
Align the arrow on the top of the filter with the bin release button.
Push down to fit securely in place.
Remove your filter
Lift the filter out of the top of the cyclone.
Tap to remove excess dust and debris.
The filter has a top with
five arms that fit onto
the cyclone body
The filter will only fit
correctly if the arms
are aligned and the
arrow on the top is
pointing towards
the main body of
the machine.
Alt text alt tex alt tex alt
tex alt tex alt tex alt tex
Alt text alt tex alt tex alt
tex alt tex alt tex alt tex
Alt text alt tex alt tex alt
tex alt tex alt tex alt tex
To Next Page
Loading...
