Service manual
Fitting notes
Please note: when attaching cables to the satellite assembly it is possible to fit
two of the cables incorrectly. It is essential to ensure all cables are attached to
the correct connectors as shown below.
After fitting the motor and attaching the cables to the satellite assembly the following parts should be
fitted as previously shown:
Cable rewind assembly (pages 17-23).
87 Attach all cables to the satellite assembly (models with finger tip controls only).
PCB EMC cable
(two wires)
Cyclone inlet cable
(Motorhead products only)
(three wires)
Switch loom cable
Motor ribbon
cable
41
To Next Page
Loading...
