15 Carefully feed the Grommets
and looms through the AMP neck
assembly.
16
16 Feed the three looms through the
hole in the neck.
17 Locate the two remaining looms inside the large grommet ensuring the larger loom is located in
the centre of the grommet.
By pushing from the inside of the neck ensure the large grommet is seated correctly.
If the Air Amp Neck Service assembly was previously removed, continue to the next step.
If the reason for the repair is to replace the entire Amp Service assembly go to page 20 step 23 - 30.
17
Repair notes
AMP Service Assembly - fitting
To Next Page
Loading...
