82 Locate the tray level sensor into the
water return tray.
83 Retain the Tray level sensor harness
into all the details provided and feed
through the top of the Main body.
84 Retain the Shuttle Harness into all
details provided and feed through the
top of the Main body.
50
After fitting the harness, continuing fitting the following components as previously shown:
Lower boby assembly (pages 31 - 35, steps 46 - 55)
Air AMP Service assembly (Pages 21 - 24, steps 25 - 30)
85 Remove the two T-8 screws holding
the Base skirt.
87 Peel away the Base skirt.
86 Unclip the retaing detail of the skirt
from the base.
Repair notes
Internal Power Harness Service Assembly - removal
51
Before continuing the following components will need to be removed as previously shown:
Air amp service assembly (Pages 10 - 11, steps 01 - 05)
Lower Body Service assembly (page 25 - 30, steps 31 - 35).
To Next Page
Loading...
