69 Fit the Motor to AMP seal.
Ensure it is the correct way up and
seated around the top of the Motor
bucket.
44
After fitting the seal, continuing fitting the following components as previously shown:
Air AMP Service assembly (Page 21 - 24, steps 25 - 30)
70 Remove the Tray Level Harness
assembly.
If the reason for the repair is to
replace the Tray Level Harness
go to page ?? step ?? for fitting
instructions.
71 Remove the four T-8 screws holding
the Shuttle Spring Spigot and Spring.
Caution: the spring is under tension.
Important: wear protective glasses .
72 Firmly slide the Connection Shuttle
away from the Water return tray until
it releases.
Repair notes
Connection Shuttle Service Assembly - removal
Before continuing the following components will need to be removed as previously shown:
Air amp service assembly (Pages 10 - 11, steps 01 - 05)
Lower Body Service assembly (page 25 - 30, steps 31 - 35).
45
To Next Page
Loading...
