34 Disconnect the Power loom from the
Power controller PCB.
35 Remove the two T-15 screws on the
right handside from behind the filter
release catch holding at the base.
36 Repeat on the opposite side.
Important: on the left handside the
hinge cover will need to be removed
to gain access to the remaining
screw.
Remove the two T-8 screws holding
the lower hinge cover. Remove the
cover.
26
37 If the Evaporator door needs
replacing, remove the two screws in
the top hinge cover and remove the
cover.
38 Open the door until the hinges pop out of the retaining details.
39 To refit the Evaporator door, squeeze
the top and bottom arms of the
hinges into the holes and locate
within the details.
27
To Next Page
Loading...
