06 This diagram is to identify all PCB’s within the main body.
If the reason for the repair is to replace any of the PCB’s or sensors this can be done at this point.
Disconnect the affected PCB or sensor. Fit a new PCB or sensor ensuring the looms are retained as
shown in diagram above.
Note: the wifi PCB can not be replaced. The machine will have to be exchanged.
For Amp fitting instructions go page 29 step 48.
* Offered together as one assembly ‘Sensor PCB service assembly’.
11
LCD display
Main PCB
Wifi PCB
Dust sensor
VOC sensor*
Sensor satelite*
Temperature/
Humidity sensor
Note: the LCD display is secured with a locking mechanism that will need to be opened
before removing/replacing.
To Next Page
Loading...
