DYU C6 - Bike Function Overview; Charging and Power Management; Bike Controls and Safety Features; Riding Modes and Booting Procedures

FUNCTION
INTRODUCTION TO METER
7.Electric & Assistant mode:The default setting is ECO
economy gear when the machine is turned on, and it can
directly accelerate when riding, and it can also use
power-assisted sensors to ride.
8. Zero speed booting and none zero speed booting. Zero
speed booting: when the E-bike on standby mode, you can
accelerate with speeding bar; None zero speed booting: the
bike boots when it runs only.
9.Hold the brake gently when going downhill,can recoverthe
part of the power and charge for your Ebike.
1. Charging: Connect the charger to the power plug and
then to the Dyu E-bike.When the charger indicator turns
green from red, it shows full power.
2. Turn on the Dyu E-bike: Push forward the boot button to
turn on the E-bike, the dash board lights up; Push back the
boot button to turn off the E-bike.
3. Switching on and off: Press the switch button, the display
shows power on when there is power, press the switch
button, the display shows off when there is no power.
4. Horn: Pressing the horn button, the horn sounds up.
Clicking recommended.When pressing for over 10 seconds,
the horn stops, you need to repress it.
5. Front light: Push the front light button forward to turn on
the front light, push it backward to turn off the front light.
6.Brake: When the brake handle is not fully rebounded
during use, it is in a power-off state and cannot be powered
up.
Power display:
Battery Define:
DC2.1
Charger
Front light switch
Trumpet
Power
display
Power
switch
Half-light switch
PUSH LOCK：Can remove battery in lock tongue retracted state, remove
battery case after remove the key;
OFF：Remove the key when lock tongue extended, non power-on;
battery case locked,immovable;
ON：Remove the key when lock tongue extended, in power-on state;
battery case locked,immovable;