E-Bike Forme - Bike Lights Control; Push-Assistance Mode; Speed and Distance Display

the eBike drive assists you while pedalling. The
while changing gears. This makes changing
gears easier and reduces the wear of the drive
train. By selecting the right gear, you can
increase the speed and range with the same
pedaling effort.
For this reason, follow the shift
recommendations provided by indications
g
and
h
on your display. If indication
g is
displayed, you should shift to a higher gear
with lower cadence.
If indication
h
is displayed, you should select a
lower gear with higher cadence.
Switching bike lights on/off
In the model in which the lighting is powered
by the eBike system, the front and rear lights
can be switched on and off at the same time
via the on-board computer with button
2
.
When the lighting is switched on
“Lights on”
appears and when the lighting is switched off
“Lights off”
appears for approx
. 1 s in text
indication
d
. The lighting symbol
c
is displayed
when the light is on.
Switching the bike light on and off has no
effect on the back lighting of the display.
Switching the Push-assistance mode On/Off
The push-assistance feature makes it easier to
push the eBike. The speed in this function
depends on the set gear and cannot exceed 6
km/h (max.). The lower the set gear, the lower
the speed in the push-assistance function (at
full output).

The push-assistance function may only be
used when pushing the eBike.
Danger of injury
when the wheels of the eBike do not have
ground contact while using the push-
assistance function. To
activate
the push-
assistance function, briefly press button
“WALK”
on your on-
board computer. After
activation, press button
“+”
within 3 s and keep
it pressed. The eBike drive is switched on.
Note:
The push assistance cannot be activated
in the
“OFF”
assistance level.
one of the following
occurs:
– you release button
“+” 12
,
– the wheels of the eBike are blocked (e.g. by
actuating the brakes or impacting against an
obstacle),
– the speed exceeds 6 km/h.
Note:
On some systems the push-assistance
function can be started directly by pressing the
“WALK”
button.
Displays and configurations of the on-board
computer
Speed and Distance Indication
The
speed indication f always displays the
current speed.
The following functions are available in the
function indication
(combination of text
indication
d
and value indication
e
):
–
“Clock”:
Current time
–
“Max. speed”: Maximum speed achieved
since the last reset
–
“Avg. speed”:
Average speed achieved since
the last reset
–
“Trip time”:
Trip time since the last reset
–
“Range”:
Estimated r
ange of the available
battery-
pack charge (for constant conditions
such as assistance level, route profile, etc.)
–
“Odometer”: Display of the total distance
travelled with the eBike (cannot be reset)
–
“ NuVinci Cadence/Gear”:
This menu item is
displayed only in conjunction with a Nu Vinci
H|Sync automatic transmission.
If you press the
“i”
button for longer than 1 s,
you will access the NuVinci menu item from
any menu item in the information menu.
To switch from the
“ NuVinci Cadence”
mode
to the
“ NuVinci Gear”
mode, press the
“i”
button for 1 s.
To switch from the
“ NuVinci Gear”
mode to the
“ NuVinci Cadence”
mode, all you have to do is
briefly press the
“i”
button.
F O R M E B I K E S . C O . U K
21