E-flight Blade SR RTF Airframe - Control and Balance Check

12
13
Center of Gravity
Once you have properly installed and secured the battery, check the helicopter’s center of gravity. With the canopy
installed, lift the helicopter by the flybar with the flybar positioned perpendicular to the tail boom. Move the battery
forwardorrearwardasrequiredtoachieveaslightlynosedownorperfectlylevelhelicopterposition.Youshouldalways
check the CG of your Blade SR before flying, especially if you are switching between different sizes and types of battery
packs.
Support by Flybar
Level or Slightly
Downward Angle
Transmitter Control Identification
Note: Before each flight ALWAYS turn the transmitter on before connecting the flight battery to the 2-in-1 unit.
After each flight, you should always disconnect the flight battery from the 2-in-1 unit before powering the
transmitter off.
Throttle Trim
Aileron Trim
Elevator Trim
Rudder Trim
Elevator Trim
Aileron Trim
Throttle Trim
Rudder Trim
Rudder/Throttle
Functions
Rudder/Elevator
Functions
Aileron/Elevator
Functions
Aileron/Throttle
Functions
Mode 1
Mode 2