E-FLITE Apprentice STS User Manual

1
1 2
3
EN
A
B
R-AIL L-AIL
R-AIL
L-AIL
Quickstart Guide
Charge the Flight Battery
Assemble the Aircraft
Install (4) AA Transmitter
Batteries (RTFAircraft)
CAUTION: See the aircraft
instruction manual for a
complete list of charging instructions
and warnings. All instructions and
warnings must be followed exactly.
Mishandling of LiPo batteries can
result in a  re, personal injury and/or
property damage.
Refer to the aircraft instruction manual for complete step-by-step instructions.
Landing Gear Wing
Tail
USB power source,
not included
Both the charge lead (A) and the balance
lead (B) must be connected for the
charge cycle to begin.
LED Indications
Flashing purple: Charging
Solid green: Charging complete
Solid red: Charging error
Loosen the nose
gear bracket screw.
Insert the nose gear
in the collar and
tighten the
screw against
the  at-spot
on the gear
wire.
Attach vertical  n and
horizontal stabilizer into place
with 2 screws.
Attach clevises to vertical and
horizontal stabilizer control horns.
Peel the
pre-installed
two-sided tape
and adhere wing
covers to the front
and back of the wing.
Slide the
two wing
halves
together
over the
carbon
wing tube.
Connect the left and right
aileron servo connectors to the
aileron servo wire
extensions from
the  ight controller.
Going from front to back
over the wing, attach 8
rubber bands to secure the
wing to the fuselage.
Connect clevises to
the control horns.
Remove the pin from nose gear bracket.
Slide the main
gear in the
slot until it
locks.
Install the stabilizer rod, then apply the
included two-sided tape to the
area where wings will meet.

E-FLITE Apprentice STS Specifications

General

Assembly time	60 min
Wing area	3320 cm²
Motor size	840kV
Motor type	Brushless
Engine type	Electric engine
Flight time	5 min
Product type	Airplane
Number of servos	6
Construction type	Bind-N-Fly (BNF)
Battery type	Li-Po
Battery voltage	11.1 V
Battery capacity	3200 mAh
Number of batteries supported	1
Product color	Multicolor

Weight and Dimensions

Length	1080 mm
Weight	1390 g
Wingspan	1500 mm
Center of Gravity (CG)	79 mm

Summary

Charge the Flight Battery

LED Indications

Explains the meaning of the flight battery charging status lights.

Install Transmitter Batteries

Assemble the Aircraft

Landing Gear and Tail Assembly

Attaching landing gear, vertical fin, and horizontal stabilizer.

Wing Assembly and Control Connections

Joining wing halves, connecting servos, and securing wing.

Find a Suitable Outdoor Flying Area

Power On the Transmitter

Install the Flight Battery and Power On Aircraft

Flight Mode and Takeoff Procedures

Flight Mode Selection

Setting the flight mode switch to Beginner Mode for initial flights.

Takeoff and Flying Instructions

Steps for arming the motor, taking off, and achieving stable flight.

PANIC Function

Landing Procedures

After Your Flight

Disconnecting Battery and Powering Off

Steps for safely disconnecting the flight battery and powering down the transmitter.

Storage Precautions

Important advice on storing the aircraft to prevent damage from heat.