18 E-flite F-15 Eagle ARF Assembly Manual
10. Slide the pushrod connector onto the pushrod wire.
After centering the steering servo using the radio, install
the servo arm on the steering servo. Center the nose
wheel and secure the pushrod wire using the setscrew
and 1.5mm hex wrench.
Note: You will need to bend the nose gear pushrod
slightly to achieve the correct alignment between the
servo and nose gear.
Retract Installation
Required Parts
Nose gear retract Main gear retract (right and left)
Wheel (3) Spring washer (3)
Servo w/hardware (4) 2mm x 8mm sheet metal screw (12)
Pushrod connector (4) Nylon nut (4)
185mm pushrod wire w/clevis 127mm pushrod wire w/clevis (3)
Y-harness
Required Tools and Adhesives
Hex wrench: 1.5mm Phillips screwdriver: #1
Threadlock Hobby knife
Side cutters
Special note: We use E-flite S75 servos to actuate the
retracts on the F-15. Because of this we use two channels
on the DX7 to actuate the retracts, channels 5 and 7.
We set the endpoint adjustments on these channels and
use a program mix with the Gear as the master channel
and Aux 2 as the slave channel. We reverse the Aux 2
channel to be sure it goes in the correct direction. Using
a Y-harness between the nose retract servo and one of
the main gear retract servos will enable you to ensure
correct operation of the retracts.
To Next Page
Loading...
