E-FLITE Conscendo Evolution 1.5m

Questions and Answers

K
Kendra CaseJul 27, 2025
What to do if my E-FLITE Conscendo Evolution 1.5m aircraft will not respond to throttle?
- D
  Daniel CombsJul 27, 2025
  If your E-FLITE Toy aircraft doesn't respond to throttle but responds to other controls, first reset the controls with the throttle stick and throttle trim at the lowest setting. Also, ensure that the throttle servo travel is 100% or greater. Check if the throttle channel is reversed and reverse it on the transmitter if needed. Finally, ensure the motor is connected to the ESC.
R
Rebecca AnthonyJul 31, 2025
How to fix oscillation in my E-FLITE Conscendo Evolution 1.5m Toy?
- C
  Cindy ChenJul 31, 2025
  If your E-FLITE Toy aircraft oscillates, it could be due to several factors. A damaged propeller or spinner can cause this, so replace the propeller assembly. Motor vibration is another potential cause; replace parts or correctly align all parts and tighten fasteners as needed. A loose receiver can also lead to oscillation; align and secure the receiver in the fuselage. Additionally, check for loose aircraft controls and tighten or secure parts like the servo, arm, linkage, horn, and control surface. Worn parts, especially the propeller, spinner, or servo, can also contribute to oscillation, so replace them. Lastly, irregular servo movement can be a culprit, so consider replacing the servo.
J
jason92Aug 5, 2025
Why is there extra propeller noise or vibration in my E-FLITE Conscendo Evolution 1.5m?
- N
  nphillipsAug 5, 2025
  If your E-FLITE Toy aircraft exhibits extra propeller noise or vibration, it might be due to damaged propeller, spinner, or motor parts, so replace any damaged components. An out-of-balance propeller can also cause this issue, so balance or replace the propeller. If the spinner screw is too loose, tighten the prop nut.
E
Elizabeth ThomasAug 9, 2025
Why does my E-FLITE Conscendo Evolution 1.5m have reduced flight time?
- S
  sarah84Aug 9, 2025
  If your E-FLITE Toy aircraft's flight time is reduced or it feels underpowered, start by completely recharging the flight battery. If the issue persists, the flight battery might be damaged, so replace it and follow the battery instructions. Cold flight conditions can also affect performance, so ensure the battery is warm before use. Lastly, the battery capacity might be too low for the flight conditions, so replace it with a larger capacity battery.
D
Drew MaloneAug 13, 2025
What to do if my E-FLITE Toy aircraft will not bind to the transmitter?
- T
  tgarciaAug 13, 2025
  If your E-FLITE Toy aircraft will not bind to the transmitter, move the powered transmitter a few feet away from the aircraft, then disconnect and reconnect the flight battery to the aircraft. Ensure that the aircraft and transmitter are not too close to large metal objects, wireless sources, or other transmitters; move them to another location and try binding again. Also, make sure you are following the correct binding process. Check that the flight battery and transmitter batteries are adequately charged, replacing or recharging them if necessary. Finally, ensure the bind switch or button is held long enough during the bind process, and repeat the process if needed.
A
Amy BuckAug 17, 2025
Why is my E-FLITE Toy flight performance inconsistent?
- D
  David DavisAug 18, 2025
  If you experience inconsistent flight performance with your E-FLITE Toy, check that the trim is at neutral. If you adjust the trim more than 8 clicks, adjust the clevis to remove trim. Ensure that sub-trim is not being used; no sub-trim is allowed, so adjust the servo linkage instead. Also, make sure the aircraft was kept immobile for 5 seconds after connecting the battery; disconnect and reconnect the battery, keeping the aircraft still for 5 seconds with the throttle stick in the lowest position.
R
Ricardo SmithAug 21, 2025
What to do if E-FLITE Toy has incorrect response to AS3X Control Direction Test?
- T
  Tonya KingAug 21, 2025
  If your E-FLITE Toy shows an incorrect response to the AS3X Control Direction Test, do not fly the aircraft. The issue is due to incorrect direction settings in the receiver, which can cause a crash. Correct the direction settings by referring to the receiver manual, then you can fly.