E-Mu 404 - The Order of Effects; Creating, Renaming & Deleting Categories or Presets; 88 Khz, 96 Khz, 176 Khz & 192 Khz Operation

5 - Effects
88kHz, 96kHz, 176kHz & 192kHz Operation
E-MU Digital Audio System 47
The Order of Effects
PatchMix DSP allows you to record your tracks without effects (dry) and monitor with
effects enabled (wet). It works like this: If the effect is inserted BEFORE the ASIO send in
the signal path, it will get recorded; if the effect is inserted AFTER the ASIO send, it will
not be recorded.
Recording dry allows you to
hear your performance with
effect (to get the proper
feel), but gives you the flexi-
bility to add or modify
effects later during
mixdown. This way if you
don’t like the way the effect
sounds, you can change or
modify the effect without
having to perform the part
again.
Creating, Renaming & Deleting Categories or Presets
There are several utilities to help you organize your effects presets.
 To Create a New Preset Category
You can create your own category folders to help organize your effects presets.
1. Left-click on the New Folder icon at the top of the Effects Palette. A pop-up dialog
box appears asking you to “Enter the Name of the New Category.”
2. Type in a name for your new folder.
3. Click OK to create a new folder or Cancel to cancel the operation.
 To Delete an Effect Category or Preset
1. Right-click on the category folder you wish to delete. A pop-up selection box
appears, warning you that this action will delete all presets in the folder.
2. Select “Delete Category”. A popup selection box appears.
3. Click OK to delete the folder or Cancel to cancel the operation.
 To Rename an FX Category
1. Right-click on the category folder you wish to rename. A pop-up selection box
appears.
2. Select “Rename Category”. A pop-up dialog box appears, asking you to “Enter New
Category Name.”
3. Click OK to rename the folder or Cancel to cancel the operation.
88kHz, 96kHz, 176kHz & 192kHz Operation
When operating at 88kHz 96kHz, 176kHz and 192kHz sample rates, the effect
processors are completely disabled. However, the Inserts, Send/Returns, Meters, Trim
Controls, Test Tones and ASIO Direct Monitoring ARE fully functional.
Output
Reverb
Return
Amount
To Monitor Speakers
Send
Amount
Aux 1 Bus
A
SIO
Send
Input
L/R
Fader
Panning
Main Output Bus
To ASIO
If you want Effects
to be recorded,
insert them Above
the ASIO Send.
To monitor Effects,
but not record them,
insert them Below
the ASIO Send or
in a Sidechain.