AVERTISSEMENT NETTOYAGE
Make sure that the Balance Bike "parking position" (stand
in position open, on a flat surface or on a slope or hilly), that
the charger is unplugged and that the balance bike is off
(off). Make sure that the charging port is protected by the
rubber plug to avoid damaging the device by introducing
water.
WARNING brakes make sure the Balance Bike in "parking
position" (stand in the open position, on a flat surface or
slope or hilly), that the charger is unplugged and that the
balance bike is off (off). Please check the brakes before
using. Make sure the voltage of the brakes and use the key
provided if they are too loose or too tight.
4) Cleaning / Maintenance / Repairs
a) Cleaning
- Clean with a damp cloth to remove dust and dirt.
- Don't use industrial cleaners or solvents since this
might damage the surfaces.
- Don't use alcohol or ammonia based cleaners as this
may damage the components.
B) Brakes: maintenance / adjustments
i) Adjustment of brake cable
tension
The manipulations are the same for front and rear brakes.
To Next Page
Loading...
