Page 16
OPERATION AND SERVICE INFORMATION
Owner’s Guide
Read all of manual to become familiar with this vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.
B
Use care when tightening fasteners and refer to the
Technician’s Repair and Service Manual for specific
torque values.
Generally, three classes of standard hardware and two
classes of metric hardware are used in the vehicle.
Grade 5 hardware can be identified by the three marks
on the hexagonal head and grade 8 hardware is identi-
fied by 6 marks on the head. Metric hardware is marked
on the head with 8.8 or 10.9. Unmarked hardware is
Grade 2.
CAPACITIES AND REPLACEMENT PARTS
Fig. 20 Torque Specifications and Bolt Grades
FLUID
PART
NUMBER
QTY
Rear Axle Lubricant
Mobilube 85W - 140
613175
25 oz.
(651 ml)
Friction Modifier E-Z-GO 611242
2 oz.
(59 ml)
Fig. 18 Capacities
ITEM PART NUMBER
Fuse ATC 10A (E-Z-GO P/N 35212G07)
Headlight Bulb 894 (E-Z-GO P/N 74004G01)
Turn Signal Bulb 912-NA (E-Z-GO P/N 74005G01)
Tail Light Bulb 2057 (E-Z-GO P/N 604311)
Fig. 19 Replacement Part
ALL TORQUE FIGURES ARE IN FT. LBS. (Nm)
BOLT SIZE
Grade 2
1/4" 5/16" 3/8" 7/16" 1/2" 9/16" 5/8" 3/4" 7/8" 1"
Unless otherwise noted in text, tighten all hardware in accordance with this chart.
This chart specifies 'lubricated' torque figures. Fasteners that are plated or lubricated when
installed are considered 'wet' and require approximately 80% of the torque required for 'dry' fasteners.
4
(5)
8
(11)
15
(20)
24
(33)
35
(47)
55
(75)
75
(102)
130
(176)
125
(169)
190
(258)
Grade 5
Grade 8
6
(8)
13
(18)
23
(31)
35
(47)
55
(75)
80
(108)
110
(149)
200
(271)
320
(434)
480
(651)
6
(8)
18
(24)
35
(47)
55
(75)
80
(108)
110
(149)
170
(230)
280
(380)
460
(624)
680
(922)
BOLT SIZE
Class 5.8
(Grade 2)
M4 M5 M6 M8 M10 M12 M14
1
(2)
2
(3)
4
(6)
10
(14)
20
(27)
35
(47)
55
(76.4)
Class 8.8
(Grade 5)
2
(3)
4
(6)
7
(10)
18
(24)
35
(47)
61
(83)
97
(131)
Class 10.9
(Grade 8)
3
(4)
6
(8)
10
(14)
25
(34)
49
(66)
86
(1
17)
136
(184)
5.8
8.8
10.9
To Next Page
Loading...
Need help?
General