6 7
1
OVERVIEW
Power off your existing automatic gate opener system
either usingthe masterswitchorat the circuitbreakerbox.
Review all the instructions before you start to avoid any
surprises duringinstallation.
HARDWAREINFO
EAGLE Open features dual output that can be used either controlling two separate
electronic gates/garage doors or controlling two functions of one electronic gate/garage
door. These outputs are connected to the control input of the central electronics of the
door / gate moverequipment(s).
There are two inputs on the deviceassociatedwith each output.Thesecan be used to sense
the stateof the correspondinggate/door.
Low-voltage power supply is provided for the device from an external source, preferably
from the power supply output installed for this purpose on the connected control panel.
In the absence thereof, an external power supply unit must be provided for operating
the device, whose output voltage is within the operational voltage range indicated in the
technicalspecifications.The EAGLE Open powersupplyinputis polarity-independent.
INSTALLATION INSTRUCTIONS
Theinstallation section of the guidehasbeen produced for trained personnel,so it is advised
to have the installation work performed by a specialist recommended by the manufacturer
and the distributor, or by the specialist who puts into operation your electronic door, gate
or barrier.
Installation works must be completed and electric connections must be established by
appropriate workingmethods anddue diligence.
The manufacturer and distributor of Nold Open are not liable for any damage arising from
incorrect,improperor unprofessionalinstallation(puttinginto operation).
To Next Page
Loading...
