4810 Clover Road • Greensboro, NC 27450 • 1-800-336-2776 • www.eagleequip.com • © Eagle Equipment 2018.01 • page 7
WARNING:
Failure to follow the unpacking and assembly directions may cause
personal injury and/or impair the operation of this machine.
PLEASE READ THOROUGHLY.
UNPACKING
1. Your equipment comes packaged as a single unit. A forklift, oor-jack or other heavy-lifting
equipment may be necessary to separate the components. Exercise caution when disassembling the
packaged equipment, as shifting may have occurred during shipping.
2. Carefully remove the packaging from the equipment. Check for any obvious
shipping damage. Remember to report any shipping damage to the carrier and make a notation on
the delivery receipt.
3. An accessory box is included with the equipment and contains smaller components.
4. Remove the equipment from the package. Literature such as the installation manual, warranty
card, and serial number plate is included inside this box.
Shipments must be inspected immediately upon receipt.
External damage must be noted on the bill of lading.
Concealed damages must be reported to the freight company within three days of delivery.
Shortages must be reported to Eagle Equipment within three days of delivery:
1-800-336-2776.
WORKPLACE REQUIREMENTS
Ensure that the workplace is in compliance with safety regulations. Connect power supply and air
source according to this manual. Make sure the location has proper air provided to ensure proper use
of the machine. This machine requires clear space from each wall (shown as Figure 2). This machine is
not recommended to be used outdoors. If installing it outdoors, it must be protected by roof against
rain and sunshine or it voids your warranty.
Figure 2Figure 1
To Next Page
Loading...