Eagle 1000A - Page 13

To Next Page

To Previous Page

- 13 -

2.3 Installation

Step 3 - If installing a ramp, place the ramp by locating the ramp shoulder bolt and

placing it into the slot in the ramp. It is highly recommended to anchor the ramp to

the floor. (See Fig. 2-5)

Step 4a (Eagle 1000B) - Affix the carriage onto the corresponding position on the mast and fasten

with four M8 bolts. Insert the connector plugs on the front of the carriage into the receptacles. Do not

force the connectors together.

(See Fig. 2-6)

Fig. 2-6

Fig. 2-5