27
CHART SPEED
The rate echoes scroll across the screen is
called the chart speed. It’s adjustable by
pressing the menu key until the chart speed
menu appears. Chart speed is set to maxi-
mum when the unit is first turned on. To
decrease it, press the down arrow key. Press
the up arrow key to increase the speed again.
The percent numbers in the Chart Speed
menu box shows the speed. Echoes scrolling
onto the screen will also show the effects of
the change. If you reach the maximum or
minimum level, an warning tone sounds.
To stop the chart, first clear any menu from the screen by pressing the
PWR key. You can’t stop the chart while a menu is displayed. Now press
the up arrow key. The chart freezes and the word “STOP” appears at the
top right portion of the screen. To start the chart, press the up arrow key
again.
digital depth display are read from the center
element only.
To turn the TargetTrack feature off, simply
press the MENU key until its menu appears as
shown at right, then press the down arrow key.
To Next Page
Loading...
Need help?
General
