General Usage
5-3
Pre-Operation Inspection Checklist
The following inspections should be conducted each day prior to the first operation of
the tractor. Additional inspections may be required due to unusual operating conditions
Walk-A-Round Inspection
- Look for evidence around and under tractor for oil, water or fuel leaks.
- Check that fuel cap is securely in place.
- Check tire rims and wheel stud nuts for possible damage.
- Check tires for under inflation, cuts, breaks or excessive wear and remove any
objects stuck in treads.
- Wipe clean, if necessary, all lights, mirrors and reflectors.
- Open engine compartment hood and check;
•Oil and coolant levels.
•Condition of all drive belts (for cracks or fraying).
•Condition of all wiring, hoses and tubing for leaks, kinks or excessive wear.
•If tractor is diesel powered, visually check fuel filters and drain the water if nec-
essary
Inside Drivers Compartment
- With the transmission in PARK and the hand brake set, start the engine.
- Check oil pressure and voltage gauges to be sure they are indicate a reading in
the normal range.
- Check fuel gauge to determine if fuel should be added.
- Sound the horn and test for excessive play in the steering wheel.
- Turn on all lights and flashers. Then exit tractor to verify they are operating prop-
erly. If the tractor is equipped with a rotating beacon, check if it is functioning.
Warning: Keep hands and clothing away from fans, belts, and any
moving parts.
To Next Page
Loading...
