EasyManua.ls Logo

EarthQuake 6015B - User Manual

EarthQuake 6015B
32 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Operator’s Manual
Original Operating Instructions
6015 Series
CRT Rototiller
P/N: 13594
ECN: 9543
Rev. 12/10/12
© 2013 Ardisam, Inc.
All Rights Reserved
Get parts online at
www.getearthquake.com
GAS/OIL
RATIO
50:1
Product #’s:
6015B (Shown)
6015BCE
6015V

Table of Contents

Questions and Answers

  • B
    Brandy PerezAug 15, 2025
    What to do if EarthQuake Tiller engine misses or lacks power?
    • T
      Terrance FloresAug 15, 2025
      If your EarthQuake Tiller engine misses or lacks power: * Raise the tines for shallow tilling by lowering the depth regulator lever. * Remove and clean the fuel tank. * Clean or replace the air cleaner. * Replace the spark plug and adjust the gap. * Drain and refill the gas tank and carburetor. If the issue persists and you suspect improper carburetor adjustment, take the tiller to an authorized engine service center.
  • R
    Reginald WilkersonAug 17, 2025
    How to fix EarthQuake 6015B Tiller engine that is hard to start?
    • H
      huntchristineAug 18, 2025
      If your EarthQuake Tiller engine is hard to start: * Drain the old fuel and replace it with fresh fuel. Consider using a gas stabilizer at the end of the season. * Make sure the spark plug wire is securely attached to the spark plug. * Ensure that the drive safety control levers are released to the neutral position to start the engine.
  • D
    Deborah HardyAug 21, 2025
    What to do if EarthQuake 6015B is difficult to control when tilling?
    • M
      michelle25Aug 22, 2025
      If your EarthQuake Tiller is difficult to control when tilling, and the machine jumps or lurches forward: * Lock the wheels in the tilling position. * Raise the tines for shallower tilling by lowering the depth regulator lever.
  • T
    Thomas MartinAug 25, 2025
    What to do if EarthQuake 6015B engine runs rough, floods during operation?
    • R
      Robert MurphyAug 25, 2025
      If the EarthQuake Tiller engine runs rough and floods during operation, you should clean or replace the air cleaner.
  • N
    Natasha RileyAug 28, 2025
    What to do if EarthQuake Tiller experiences excessive heat build up in transmission/tine area during tilling?
    • E
      Eric WhiteAug 28, 2025
      If there is excessive heat build-up in the transmission/tine area of your EarthQuake Tiller during tilling: * Remove vegetation following the instructions in the Clean Tine Axle Shaft of Normal Care section, adhering to all safety instructions. * Check the transmission fluid and fill if needed.
  • J
    Jonathan JonesAug 31, 2025
    What to do if EarthQuake 6015B Tiller tines turn, but wheels do not turn?
    • A
      Anthony FisherAug 31, 2025
      If the tines turn, but the wheels do not turn on your EarthQuake Tiller, lock the wheels in the tilling position. If the problem persists, this may indicate an internal transmission failure; see your dealer.
  • A
    April ContrerasSep 4, 2025
    What to do if EarthQuake 6015B tines turn, wheels turn, but tiller does not move?
    • M
      mary71Sep 4, 2025
      If the tines and wheels turn, but the EarthQuake Tiller does not move, lower the tines for deeper tilling by raising the depth regulator lever.
  • W
    whitney08Sep 7, 2025
    How to fix EarthQuake Tiller belts squealing in neutral?
    • B
      braystephanieSep 7, 2025
      To adjust the forward belt guide on your EarthQuake Tiller: * Turn the engine off and allow the muffler to cool. * Disconnect the spark plug wire and secure it away from the spark plug. * Remove the belt guard. * Pull down on the drive safety control lever. * Manually bend the forward belt guide so there is 1/16 inch or less clearance between the belt guide and the belt. * Replace the belt guard and spark plug wire.
  • B
    bryantsethSep 12, 2025
    What to do if EarthQuake 6015B moves forward during starting?
    • C
      Christopher WilliamsSep 12, 2025
      If your EarthQuake Tiller moves forward during starting, make sure the drive safety control levers are released to the neutral position to start the engine.

Summary

Introduction and Information

Federal Emission Information

Information regarding the tiller's compliance with U.S. EPA regulations.

Registration and Ownership Records

Instructions for registering the product and recording ownership details for warranty and service.

Safety and Precautions

Owners Responsibility

Outlines the owner's duties for safe assembly, operation, and maintenance of the rototiller.

Important Safety Precautions

Critical safety guidelines for operating the tiller, emphasizing emergency stop function and user familiarity.

California Proposition 65 Warning

Warning about engine exhaust containing chemicals known to cause cancer or reproductive harm.

Fuel Handling Safety

Guidelines for safely handling flammable fuel, including container use and filling procedures.

Operation and Maintenance Basics

Operation Guidelines

Key operational instructions, including wheel lock pins and safety warnings.

Maintenance and Storage Overview

General guidance on keeping the machine in safe working condition and preparing for storage.

Safety Decals and Information

Safety Decals Overview

Explains the purpose and location of safety labels on the rototiller for user awareness.

Key Safety Warnings

Highlights critical safety warnings such as avoiding injury, locking wheels, and keeping clear of tines.

CE Specific Warnings

Details safety information relevant to CE-certified units, including noise and vibration limits.

Unpacking and Assembly

Unpacking the Rototiller

Step-by-step instructions for unpacking the tiller and identifying all included parts.

Handlebar Assembly

Detailed instructions for attaching the handlebar extensions and the main handlebar to the tiller.

Assembly and Initial Setup

Attaching Tine Side Shields

Procedure for correctly mounting the tine side shields to the tiller for protection.

Filling Engine Crankcase

Essential steps for adding the correct type and amount of oil to the engine crankcase before operation.

Rototiller Features

Component Identification

Visual guide to the main components and controls of the rototiller.

Pre-Start Operations

Pre-Start Inspection Checklist

A comprehensive checklist of items to verify before starting the tiller's engine.

Critical Operation Warnings

Warnings regarding gasoline safety, wheel lockouts, and the need for pre-start checks.

Starting the Rototiller

Cold Start Procedure

Step-by-step guide for starting the engine from a cold state using choke and throttle controls.

Warm Start and Speed Control

Instructions for restarting a warm engine and setting idle and operating speeds.

Controls and Operation

Drive Safety Control Lever

Explanation of the drive safety control lever's function for engaging and disengaging tines and wheels.

Tilling and Shutting Down

Guidance on adjusting depth, tilling, and safely shutting down the engine and tiller.

Hot Surface Warnings

Important warnings about extremely hot engine parts and the muffler area.

Wheel Lock Pin Operation

Free-Wheel Position

Instructions for setting wheels to free-wheel for easier transportation and storage.

Tilling Position

Instructions for locking wheels to enable forward propulsion and tilling.

Operational Safety Notes

Cautions and warnings regarding control operation and using the free-wheel position.

Depth and Belt Adjustments

Depth Regulator Lever Adjustment

Steps to adjust the depth regulator lever for desired tilling depth.

Belt Tension Adjustment

Procedure for checking and adjusting the drive belt tension for optimal performance.

Depth Adjustment Safety

Warning to only adjust depth when the drive control lever is in neutral.

Tilling and Cultivating

Tilling Tips

Advice on achieving successful tilling by starting shallow and gradually increasing depth.

Cultivating Tips

Guidance on using the tiller for cultivating tasks, like weed control and soil aeration.

Tilling Depth Caution

Extreme caution advised for tilling depth to prevent loss of control; stop engine for debris removal.

Maintenance Schedule and Servicing

Maintenance Schedule

A table outlining recommended maintenance operations and their service intervals.

Servicing the Rototiller

Information and procedures for performing routine maintenance checks and services.

Prevent Accidental Starting

Crucial safety warning to disconnect the spark plug wire before any maintenance.

Changing the Forward Belt

Belt Replacement Procedure

Step-by-step instructions for safely removing and installing the forward drive belt.

Operational and Engine Warnings

Warnings regarding engine overheating and hot muffler areas during operation.

Engine and Component Maintenance

Engine Maintenance Overview

Reference to the engine manual for detailed maintenance tasks and schedules.

Crankcase and Transmission Checks

Procedures for checking and filling the engine oil and transmission grease levels.

Lubrication and Cleaning

Instructions for lubricating moving parts and cleaning the tine axle shaft.

Tire Pressure

Recommended tire pressure for proper tiller operation and to prevent pulling to one side.

Storage Preparation

Preparing for Storage

Detailed steps to prepare the tiller for long-term storage, including fuel and engine care.

Storage Area Safety

Warning about safe storage locations to prevent fire hazards from fuel fumes.

Troubleshooting Guide

Common Problems and Remedies

A guide to diagnosing and resolving common issues encountered with the rototiller.

Maintenance Safety Requirement

Emphasizes engine shutdown and spark plug wire disconnection before any repair work.

Warranty Information

Product Limited Warranty

Details the one-year limited warranty for the rototiller, including coverage and registration requirements.

Engine Emissions Warranty

Outlines the two-year limited warranty for the Viper® Engines' emissions control systems.

Emissions Control Warranty Details

Emissions Warranty Provisions

Explains EPA compliance and Ardisam's warranty for Viper® Engines' emission systems.

Maintenance and Repair Requirements

Owner's responsibilities for engine maintenance, record-keeping, and warranty repair procedures.

Warranty Limitations

Lists conditions that void the warranty, such as misuse, neglect, or unauthorized modifications.

EarthQuake 6015B Specifications

General IconGeneral
BrandEarthQuake
Model6015B
CategoryTiller
LanguageEnglish

Related product manuals