What to do if EarthQuake 7055 moves forward during starting?
If your EarthQuake Tiller moves forward during starting, ensure the drive safety control levers are released to the neutral position to start the engine.
What to do if EarthQuake 7055 is difficult to control when tilling?
If your EarthQuake Tiller is difficult to control when tilling (if the machine jumps or lurches forward), lock the wheels in the tilling position. Also, raise the tines for shallower tilling by lowering the depth regulator lever.
What to do if EarthQuake 7055 engine will not stop?
If the EarthQuake Tiller engine will not stop when the throttle control is positioned at stop, check and adjust the throttle linkage. Consult the engine manual for instructions.
What to do if there is excessive heat build up in transmission/tine area during tilling of EarthQuake Tiller?
Remove vegetation by following the instructions in the Clean Tine Axle Shaft of Normal Care section, while adhering to all safety instructions. Also, check the transmission fluid and refill it if needed.
General| Engine Displacement | 212cc |
|---|---|
| Tilling Depth | 8 inches |
| Tine Material | Steel |
| Forward Rotating Tines | Yes |
| Reverse Rotating Tines | No |
| Warranty | 2 years |
| Engine Type | 4-Cycle |
| Drive System | Chain Drive |
To Next Page
