What to do if my EarthWise SN71018 motor shuts off during operation?
If your EarthWise Snow Blower motor shuts off during operation, it may be due to high current. To resolve this, push the reset button and then restart the snow thrower.
Why EarthWise SN71018 Snow Blower motor does not start?
If the EarthWise Snow Blower motor does not start, the issue might be that the unit isn't properly plugged in, there's no electricity, or the cable is defective. Ensure the unit is plugged in, check the power supply, and inspect the cable. If the cable is damaged, repair or replace it.
How to fix poor results with EarthWise SN71018?
Poor results with your EarthWise Snow Blower can stem from several causes: a worn or damaged drive belt, a worn or damaged auger, or a blocked discharge chute. Here's how to address these issues: * Replace the drive belt if it's worn or damaged. * Replace the auger if it's worn or damaged. * Ensure all screws and nuts are properly tightened. * Switch off the snow thrower and clean the discharge chute.
Why is my EarthWise Snow Blower experiencing abnormal vibrations?
Abnormal vibrations in your EarthWise Snow Blower can be caused by a worn or damaged drive belt, a worn or damaged auger, or a worn or damaged scraper blade. To address this: * Replace the drive belt. * Replace the auger. * Replace the scraper blade. Also, make sure the screws and nuts are properly tightened.
Provides essential safety guidelines for operating the snow thrower, covering electrical, environmental, and personal precautions.
Instructions for removing the snow thrower and all parts from the shipping box and checking for damage.
Step-by-step guide for connecting handles, chute crank, and deflector to assemble the snow thrower.
Instructions on how to start and stop the snow thrower safely, including safety lock operation.
Guidance on preparing the area, operating the snow thrower, and clearing snow efficiently and safely.
Instructions for removing and installing a new scraper blade at the base of the snow thrower.
Procedure for replacing the auger belt, including accessing the belt drive system.
General| Clearing Width | 18 inches |
|---|---|
| Power Source | Electric |
| Motor Power | 13.5 Amp |
| Weight | 35 lbs |
| Corded/Cordless | Corded |
| Cut Depth | 12 inches |
| Auger Material | Plastic |
| Chute Control | Manual |
| Throw Distance | 30 ft |
| Starter Type | Electric |
To Next Page
