To Next PageTo Next PageWhat to do if EarthWise SN74018 motor does not start?
If the motor of your EarthWise Snow Blower doesn't start, there are several potential causes. First, make sure the battery is fully inserted and making contact. Second, ensure the lock off is fully forward before moving the trigger. Third, verify the battery is installed properly. Finally, check the battery charging requirements to ensure it's adequately charged.
Why EarthWise Snow Blower has abnormal vibrations?
Abnormal vibrations in your EarthWise Snow Blower can stem from a few issues. The drive belt might be worn or damaged, necessitating a replacement. Similarly, the auger could be worn or damaged and need replacing. Lastly, a worn or damaged scraper blade could be the culprit; replace it and ensure the screws are properly tightened.
What to do if EarthWise SN74018 gives poor results?
Poor results with your EarthWise Snow Blower can be due to several factors. A worn or damaged drive belt may need replacement. Also, the auger could be worn or damaged, requiring replacement. Additionally, check for a blocked discharge; if blocked, switch off the snow thrower, remove the battery pack, and clean the discharge, ensuring the screws and nuts are properly tightened.
What to do if EarthWise SN74018 Snow Blower battery LED lights will not illuminate?
If the battery LED lights on your EarthWise Snow Blower battery won't illuminate, it might be in sleep mode. To resolve this, place the battery on the charger for one to two minutes.
General| Clearing Width | 18 inches |
|---|---|
| Intake Height | 12 inches |
| Clearing Depth | 12 inches |
| Throw Distance | Up to 25 feet |
| Starter Type | Recoil |
| Chute Control | Manual |
Inspect all parts for damage before use to ensure proper function.
Avoid hazardous environments, ensure good lighting and storage.
Wear appropriate safety glasses, clothing, and footwear. Stay alert.
Follow safe practices for starting, operating, and overloading.
Handle charger cords carefully and use only recommended attachments.
Operate charger within temperature limits; avoid damage and wet conditions.
Use correct gauge, condition extension cords if needed.
Information regarding radio frequency interference compliance.
Carefully unpack all components and inspect for shipping damage.
Step-by-step guide for attaching the center handle securely.
Proper battery installation and understanding the charge level indicators.
Safe procedures for turning the snow thrower on and off.
How to use the LED headlights for visibility in low light.
Effective methods for clearing snow and handling different snow depths.
Maintain the snow thrower by cleaning and checking fasteners regularly.
Information regarding the sealed bearings and lubrication needs.
Instructions on how to remove and install a new scraper.
Step-by-step guide for replacing the auger belt.
How to detach and attach new rubber plates to the auger.
Understanding the LED lights to check battery capacity.
How to charge the battery and interpret the status indicator lights.
Diagnosing issues indicated by abnormal light patterns.
How to manage battery indicator lights entering sleep mode.
Guidelines for storing the snow thrower and battery safely.
Identify causes and remedies for a motor that fails to start.
Address issues like poor results or abnormal vibrations.
Solutions for when battery LED lights are not illuminating.
What the limited warranty covers and specific exclusions.
Warranty applies only to original purchaser from authorized retailers.
Exclusions for indirect, consequential, or incidental damages.
Original dated sales receipt is mandatory for warranty claims.
