EasyManua.ls Logo

EAS Electric EMD12I - Troubleshooting Tips; Technical Problems; General Problems; Noise Issues

EAS Electric EMD12I
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
71
9.TROUBLESHOOTING TIPS
Problem
Possible CausesWhat To Do
Dishwasher doesn't
Fuse blown, or the
Replace fuse or reset circuit breaker. Remove any other
start
circuit breaker acted
appliances sharing the same circuit with the dishwasher
Power supply is not
Make sure the dishwasher is turned on and the door is
turned on
closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Water pressure is low
Check that the water supply is connected properly and
Technical
the water is turned on.
Door of dishwasher
problems
Make sure to close the door properly and latch it.
not properly closed.
water not pumped
Kink in drain hose
Check drain hose.
from dishwasher
Filter clogged
Check the coarse filter
(see section titled " Cleaning The Filter ")
Kitchen sink clogged
Check the kitchen sink to make sure it is draining well.
If the problem is the kitchen sink not draining ,you may
need a plumber rather than a serviceman for dishwashers.
Suds in the tub
Improper detergent
Use only the special dishwasher detergent to avoid suds.
If this occurs, open the dishwasher and let suds evaporate.
Add 1 gallon of cold water to the tub. Close and latch the
dishwasher, then select any cycle. Dishwasher will drain
out the water at the first step.Open the door after draining
is stop and check if the suds is disappeared.
Repeat if necessary.
Spilled rinse-aid
Always wipe up rinse-aid spills immediately.
Stained tub interior
Detergent with
Make sure that the detergent is the one without
colourant was used
colourant.
White film on
Hard water minerals
To clean the interior, use a damp sponge with
General inside surface
dishwasher detergent and wear rubber gloves.
problems
Never use any other cleaner than dishwasher
detergent for the risk of foaming or suds.
There are rust
The affected items are
stains on cutlery
not corrosion resistant.
A programme was not
Always run the quick wash programme .
run after dishwasher
without any crockery in the dishwasher and
salt was added.
without selecting the Turbo function (if present),
Traces of salt have
after adding dishwasher salt.
gotten into the wash cycle.
The lid of the softer
Check the lip .Ensure the fix is fine.
is loose
Knocking noise
A spray arm is
Interrupt the programme, and rearrange the items
in the wash cabinet
knocking against
which are obstructing the spray arm.
an item in a basket
Rattling noise
Items of crockery
Interrupt the programme,
in the wash cabinet
are loose in the
and rearrange the items of crockery.
Noise
wash cabinet
V.1

Table of Contents

Related product manuals