2. Fill up inside with water partially, and hold on
both ends of the hosepipe by two persons, then
measure the height for the 4 corners of the
machine horizontally & diagonally, repeat it several
times. See which one is the highest, then increase
the height of the other 3 corners to the same level
& measure again until confirmed to be the same.
Then it is ok for the leveling.
Notice: get all the fours supporting pedestals hold
machine tightly by adjust the screw on pedestals
first.
Following parts in red circle are supporting pedestal for SOT machine, please adjust the levelness of
machine by these supporting pedestal.
To Next Page
Loading...