B6 Swivelling o the drive rollers:
Secure the vehicle against rolling o
before swivelling o the drive rollers!
GB10
Pull the handbrake and/or secure your caravan or
trainer with trestles against unintended rolling-o.
Switch OFF the main or remote
switch, depending on the model.
Switch o your easydriver by pressing the
I/O button on your remote control unit once.
B7 Switching OFF the easydriver
The drive units may not remain engaged on the tyres,
as this might damage the tyres. Driving with a towing
vehicle while the drive units are connected is prohibit-
ed, as it might damage the caravan or trailer as well as
the towing vehicle.
B8 Switching OFF the system
7. Commissioning/operation
8. Notes/warnings
The easydriver uses bidirectional communication be-
tween the remote control and the base station. This
makes it possible to transfer information from the base
station to the remote control.
Operating status display LED, blue
1x flashing per second: searching for the
base station
Permanently lit up: Connected to the base
station, system ready for operation.
Remote control battery LED, red
Symbol not lit up: Battery voltage is in order
1x per second flashing: Batteries should be
exchanged
Permanently lit up: Batteries empty. All
driving functions are terminated.
8. Notes/warnings
The easydriver must be switched o after
every operation by using these switches.
.
English
Press the two arrow buttons on the
remote control and hold them down
until the drive rollers have been fully
retracted.
The display flashes until the swivelling-o process has
been completed. The motor drive automatically switch-
es o when the end position has been reached. The
symbol is permanently lit up once the swivelling-o
process has been completed.
To Next Page
Loading...
