EasyManua.ls Logo

Easylift R130 - Page 31

Default Icon
127 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31
ISTRUZIONI E NORME DI SICUREZZA
SAFETY INSTRUCTION AND RULES
R
130
PREPARAZIONE ED ISPEZIONE
MANUTENZIONE DELLE BATTERIE
Per evitare ferimenti causati da esplosioni, non fumare nei
pressi delle batterie ne avvicinare una fiamma o una fonte di
scintille durante la manutenzione.
Le batterie non necessitano di manutenzione, fatta ec-1
cezione per la pulizia saltuaria dei terminali come descritto
di seguito.
Rimuovere i cavi da ogni polo della batteria uno alla volta,2
cominciando dal polo negativo. Pulire i cavi con una
soluzione neutra (esempio: bicarbonato di soda e acqua o
ammoniaca) e uno spazzolino metallico.
Sostituire i cavi elettrici o le viti dei morsetti dei cavi se nec-3
essario.
Pulire i poli della batteria con uno spazzolino metallico4
quindi ricollegare i cavi ai poli. Ungere le superfici che non
sono in contatto con grasso minerale o vaselina.
Quando tutti i cavi e i poli sono stati puliti, assicurarsi che i5
cavi siano fissati correttamente e non siano compressi.
Chiudere il coperchi del vano delle batterie.6
MANUTENZIONE DELLA MOTOPOMPA
Attenersi al manuale specifico del costruttore.1
PREPARATION AND INSPECTION
MAINTENANCE OF THE BATTERIES
To avoid injury caused by explosion, do not smoke
near the batteries or bring a naked flame or a source of sparking
close during maintenance work.
The batteries do not need maintenance except for the oc-1
casional cleaning of the terminals as described below.
Remove the cables from each terminal of the battery one2
at a time beginning with the negative terminal. Clean the
cables with a neutral solution (for example: sodium bicar-
bonate and water or ammonia) and a metal wire brush.
Replace the electrical cables or the screws in the terminals3
if necessary.
Clean the terminals of the battery with a metal wire brush4
then reconnect the cables to the terminals. Apply mineral
grease or vaseline to the surfaces that are not in contact.
When all the cables and terminals have been cleaned5
make sure that the cables are secured correctly and not
squashed.
Close the battery housing cover panel.6
MOTOR PUMP MAINTENANCE
Follow the instructions given in the manufacturer's manual. 1
IMPORTANTE
Indossare sempre occhiali protettivi quando si ese-
gue la manutenzione delle batterie.
Always wear protective goggles when doing main-
tenance on the batteries.
IMPORTANT