20
more than half a second (less than 2 seconds) to determine whether the CF function is used or not. If used,
select 50HZ or 60HZ according to you. It is determined by yourself, the default value is 50HZ.
④ Confirm the OPF selecting interface. After selecting 50HZ or 60HZ, press and hold the function setting
key
for more than half a second (less than 2 seconds). Now, the OPF setting function is completed
and the “50HZ” or “60HZ” will light without flash.
⑤Exit from the setting interface. Press and hold function setting key
for more than 2 seconds, exit from
the setting interface and return to main interface.
4.6.7 ID setting
① Enter the setting interface. Press and hold the function setting key
for more than 2 seconds, then come
to setting interface, press and hold the inquiring key (
, ) for more than half a second(less than 2
seconds), select the function setting, choose output voltage setting interface, at the moment, the letters “Id”
will flash.
② Enter the output voltage setting interface. Press and hold the function setting key
for more than half a
second(less than 2 seconds), then come to setting interface of ID, at this time, the letters “Id” will not flash
any more. The numerical value next to the “Id” will flash. Press and hold the inquiring key (
, ) for
more than half a second (less than 2 seconds), select the numerical value. The provided ID numbers are 1,
2, 3, 4, 5, 6, 7, 8, you can choose anyone by yourself (The default value is 1).
③ Confirm the output voltage setting interface. After selecting numerical value, press and hold the function
setting
for more than half a second (less than 2 seconds). Now, the ID setting function is completed
and the numerical value will light without flash.
④ Exit from the setting interface. Press and hold function setting key
for more than half a second (less
than 2 seconds), exit from the setting interface and return to main interface.
Note: ID only can be set before doing parallel operation.
4.7 Parameters inquiring operation
To Next Page
Loading...