8Toxin Shield+ | Installation & Service Manual
System Start-Up (After installation is complete)
1) Open two faucets inside the home.
2) Turn the bypass valve into the service position.
3) Fill the lter with water by turning on the water service valve SLOWLY.
4) Close the two open faucets inside the home.
5) Check installation for leaks.
6) Backwash the unit until water runs clear.
7) Press and Hold the REGEN button for 5 seconds to initiate an immediate regeneration.
8) Let homeowner know the system will be regenerating for the next 16 minutes. During this time
they will have water to the home, but it will be untreated until regeneration is complete.
To Next Page
Loading...