Why EasyWater Water Dispenser has air in pipes?
If you notice air coming from your EasyWater Water Dispenser faucets, it might be because the system is trying to backwash at the same time as another system. To resolve this, set the systems so their backwash cycles don't overlap.
What to do if EasyWater Toxin Shield+ TS+1000 has no power?
If your EasyWater Water Dispenser isn't getting power, ensure that the unit is plugged in and receiving power. Also, check that the system isn't connected to a switch that might be turned off.
What to do if EasyWater Toxin Shield+ TS+1000 Water Dispenser motor stopped or jammed?
If the motor in your EasyWater Water Dispenser has stopped or is jammed, check the motor and replace it if necessary.
What to do if EasyWater Toxin Shield+ TS+1000 Water Dispenser drain line is kinked?
To ensure proper drainage for your EasyWater Water Dispenser, make sure the drain line is as straight as possible, without any kinks.
What to do if EasyWater Water Dispenser drain fitting or drain line blocked?
If you suspect a blockage in your EasyWater Water Dispenser, check the drain fitting and drain line and clear any obstructions.
What to do if EasyWater Toxin Shield+ TS+1000 Water Dispenser has debris in head?
If there's debris in the head of your EasyWater Water Dispenser, remove the piston and check for any debris. Clean if necessary.
What to do if EasyWater Water Dispenser has a defective motor?
If the motor in your EasyWater Water Dispenser is defective, replace it.
What to do if EasyWater Toxin Shield+ TS+1000 media is fouled?
If the media in your EasyWater Water Dispenser is fouled, replace it.
What to do if EasyWater Toxin Shield+ TS+1000 is not backwashing frequently enough?
If your EasyWater Water Dispenser isn't backwashing often enough, increase the backwash frequency.
How to fix internal leak in EasyWater Water Dispenser control?
To address an internal leak in the control of your EasyWater Water Dispenser, inspect the piston, seals, and spacers, and replace them if necessary.
Guidance on selecting the optimal location for filter installation, considering water lines and drains.
List of necessary tools, pipe types, fittings, and materials for connecting the filter system.
Procedure for setting the current time on the controller, especially after a power outage.
Instructions to trigger an additional regeneration cycle for increased capacity.
Steps to initiate an immediate regeneration cycle due to water quality issues or high usage.
General| Product Name | EasyWater Toxin Shield+ TS+1000 |
|---|---|
| Operating Temperature | 40-100°F |
| Installation | Under Sink |
| Capacity | 1000 gallons |
| Product Type | Under Sink Water Filter |
| Type | Under Sink |
| Contaminant Removal | Lead, Chlorine, Heavy Metals |
| Filter Life | 1000 gallons |
| Color | White |
| Warranty | 1 year limited warranty |
To Next Page