Why does my Eaton Power Tool undesirably trip?
Your Eaton Power Tool might be undesirably tripping due to several reasons: * The Trip Coil Clapper might not be resetting properly. * There could be poor engagement or worn surfaces on the Trip Bar or Trip Latch. * The Trip Bar Reset Spring may have lost torque.
What to do if Eaton Power Tool fails to trip?
If your Eaton Power Tool fails to trip, check the following components: * Trip Bar and Trip Latch for jamming. * Pole Shaft for jamming. * Operating Rod Assembly for breakage or loose pins.
General| Brand | Eaton |
|---|---|
| Model | 150VCP-W1000 |
| Category | Circuit breakers |
| Language | English |
Details VCP-W circuit breaker ratings, including voltage, current, and insulation levels.
Guides on performing a manual operation check of the circuit breaker.
Details how to perform electrical operation checks on the circuit breaker.
Provides instructions for inserting and removing the circuit breaker from its compartment.
Explains how to perform operation checks after insertion.
Discusses how the breaker interfaces with the switchgear structure.
Details interlocks and procedures for checking safe and proper operation.
Explains the stored energy mechanism used for closing and tripping.
Explains the operation of the stored energy mechanism for charging springs.
Refers to interlocks and their interfacing with switchgear structures.
Provides guidelines for determining inspection and maintenance frequency.
Defines who is considered qualified for equipment operation and maintenance.
Outlines detailed inspection and maintenance steps for various components.
Details the AC high potential test for vacuum interrupter integrity.
Describes how to check primary and secondary insulation integrity.
Details the procedure for measuring primary circuit resistance.
Provides instructions for performing the CloSure™ Test to monitor mechanism ability.
Presents a troubleshooting chart for common circuit breaker issues.
To Next Page
