Why does my Eaton Power Tool undesirably trip?
Your Eaton Power Tool might be undesirably tripping due to several reasons: * The Trip Coil Clapper might not be resetting properly. * There could be poor engagement or worn surfaces on the Trip Bar or Trip Latch. * The Trip Bar Reset Spring may have lost torque.
What to do if Eaton Power Tool fails to trip?
If your Eaton Power Tool fails to trip, check the following components: * Trip Bar and Trip Latch for jamming. * Pole Shaft for jamming. * Operating Rod Assembly for breakage or loose pins.
General| Voltage Rating | 15 kV |
|---|---|
| Current Rating | 1200 A, 2000 A, 3000 A |
| Type | Vacuum Circuit Breaker |
| Poles | 3 |
| Rated Voltage | 15 kV |
| Rated Continuous Current | 1200 A, 2000 A, 3000 A |
| Rated Short Circuit Current | 50 kA |
| Rated Frequency | 50/60 Hz |
| Interrupting Medium | Vacuum |
| Mechanical Life | 10, 000 operations |
| Operating Mechanism | Spring Stored Energy |
| Control Voltage | 125 V DC |
To Next Page