Page 20
620-00082-02-i (en)
Battery tray removal on rack models
A
B
A - Remove the front panel.
B - Remove the left-hand side of the
front panel by pushing the button
and then by sliding the part.
C
C - Disconnect the battery block by
separating the two connectors
(never pull on the wires).
D
D - Remove the metal protection cover
in front of the battery (two screws).
E
E - Pull the plastic tab to remove
the battery block and replace it.
Mounting the new battery module
Carry out the above instructions in reverse order.
• To ensure safety and high performance, use only batteries supplied by EATON.
• Take care to firmly press together the two parts of the connector during remounting.
5. Maintenance
To Next Page
Loading...
