What to do if Eaton UPS green button flashes and beeps?
If the green button on your Eaton UPS is flashing and an alarm beeps every 3 seconds, the battery backup outlets are likely overloaded. Try disconnecting some equipment from the battery backup outlets.
Why is my Eaton 5S 850 UPS operating on battery when AC power is available?
If your Eaton UPS is running on battery power even when AC power is available, it might be due to the circuit breaker being tripped by an overload. Disconnect some of the connected equipment and then reset the circuit breaker by pressing the corresponding button.
What to do if Eaton 5S 850 doesn't supply power to connected devices during AC failure?
If your Eaton UPS isn't supplying power to connected devices when AC power fails, ensure that the devices are connected to the battery backup outlets.
Why Eaton UPS EcoControl outlets keep powered when main application is stopped?
If the EcoControl outlets on your Eaton UPS remain powered even after the main application (Master outlet) is stopped, it could be because the EcoControl function isn't activated or properly configured. Activate or properly set the EcoControl function using the software provided with the product.
General| Capacity | 850 VA / 510 W |
|---|---|
| Output Power | 510 W |
| Input Voltage | 230V |
| Output Voltage | 230V |
| Form Factor | Tower |
| Number of Outlets | 8 |
| Communication Ports | USB |
| Audible Alarm | Yes |
| Frequency | 50/60 Hz |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -15°C to 45°C |
| Topology | Line-Interactive |
| Input connection | IEC 320 C14 |
| Battery Type | Sealed Lead-Acid (SLA) |
| Humidity | 0% to 95% non-condensing |
| Output Connections | IEC C13 |
To Next Page
