Why is my Eaton 5S 700 UPS operating on battery when AC power is available?
If the Eaton UPS operates on battery power even when AC power is available, it might be because the circuit breaker located at the rear of the UPS has been tripped due to an overload. To resolve this, disconnect some equipment and reset the circuit breaker by pressing the corresponding button.
What to do if Eaton UPS green button flashes and beeps?
If the green button on your Eaton UPS flashes and an audible alarm beeps every 3 seconds, it means that the battery backup outlets are overloaded. To fix this, disconnect some of the equipment connected to the battery backup outlets.
What to do if fault sign appear on Eaton UPS LCD panel?
If the fault sign appears on the LCD panel of your Eaton UPS and an audible alarm beeps continuously, it indicates a fault has occurred within the UPS, and the battery backup outlets are no longer supplied. In this case, call post-sales support.
What to do if Eaton 5S 700 UPS connected devices are not supplied when AC power fails?
If connected devices aren't getting power from the Eaton UPS during an AC power failure, ensure they are connected to the battery backup outlets.
Critical safety instructions to follow before installation.
Initial steps for setting up the UPS.
Guidelines for battery disposal and the replacement procedure.
Explanation of the UPS LCD display, indicators, and measurements.
Details on surge protection and battery backup outlets.
How to operate and set up EcoControl outlets for energy saving.
Information on the UPS battery charging process.
How to turn on the UPS and details on outlet functionality.
How the UPS manages AC power interruptions and disturbances.
Procedures for shutting down outlets and surge protection features.
Solutions for common issues encountered with the UPS.
General| Power Rating | 700 VA |
|---|---|
| Output Power | 420 W |
| Input Voltage | 230 V |
| Output Voltage | 230 V |
| Output Voltage Regulation | ± 10% |
| Frequency | 50/60 Hz |
| Communication Ports | USB |
| Surge Protection | Yes |
| Transfer Time | 2 - 6 ms |
| Form Factor | Tower |
| Weight | 5.5 kg |
| Operating Temperature | 0 °C to 40 °C |
| Operating Humidity | 0% to 95% non-condensing |
| Topology | Line Interactive |
| Outlets | 4 x IEC C13 |
| Battery Type | Sealed Lead Acid |
| Typical Backup Time at 50% Load | 9 min |
| Typical Backup Time at 70% Load | 5 min |
| Typical Backup Time | Varies by load |
| Safety Certifications | CE |
| Battery Runtime | Varies by load |
To Next Page
