P-164000427 SMALL and LARGE BATTERY CABINET 4
Revision 2 User's and Installation Guide
• The
operating environment should
be
maintained within
the
parameters stated
in
this
manual.
• Keep
surroundings uncluttered,
clean, and free from
excess moisture.
•
Observe
all DANGER, CAUTION, and WARNING
notices
affixed to the
outside
of the
equipment.
1.4
Audience
The intended audience of this manual is people who plan the installation, install, and use the
UPS. This manual provides guidelines for checking the delivery, installing, and operating of the
battery cabinet.
The
reader
is
expected
to know the
fundamentals
of electricity, wiring, electrical
components
and
electrical
schematic symbols.
This manual is
written
for a global
reader.
NOTE
Read the
manual before operating
or
working
on the
UPS system.
1.5 CE
marking
The
product
has the CE marking in
compliance
with the following
European directives:
•
LV
Directive (Safety)
2006/95/EC
Declaration
of
conformity
with UPS
harmonised standards
and
directives
EN 62040-1 (Safety) are
available at
www.eaton.eu/93PM
or by
contacting
your
nearest
Eaton office
or
authorized partner.
1.6 User
precautions
The only user
operation permitted is:
•
Switch ON or OFF the battery circuit breaker.
The user
must
follow the
precautions
and only
perform
the
described operations.
Any deviation
from
the
instructions
could be
dangerous
to the user or
cause accidental loss of load power.
WARNING
The user is not permitted to open any screws excluding the transparent hatch in front of
the battery circuit breaker. Failure to recognize the electrical hazards could prove fatal.
To Next Page
Loading...
