To Next PageTo Next Page
Need help?Do you have a question about the Eaton CL-7 and is the answer not in the manual?
General| Brand | Eaton |
|---|---|
| Model | CL-7 |
| Category | Control Unit |
| Language | English |
General caution and warning statements for equipment operation and safety.
Describes the components and features of the lower section of the front panel.
Details the upper front panel, including its display and interface.
Details wiring options for 120 Vac external power applications.
Details wiring options for 240 Vac external power applications.
How to use function codes to read and edit control parameters.
Steps for initial setup and service of the control.
Performing an operational check before installing the control on the regulator.
Performing an operational check after the control is programmed and installed.
Guidance on determining the neutral position for safe removal from service.
Procedure for installing a new control into the enclosure.
Describes the sequence of operations in automatic mode.
Explains manual operation using the front panel switches.
Defines the target voltage level for regulation.
Defines the voltage range considered within acceptable limits.
Time before a tap change occurs after voltage goes out-of-band.
Settings to compensate for voltage drop on the line.
Settings for wye or delta connected regulators.
Quick start setup for basic regulation.
Immediate access to basic control information via Hot Key.
For applications where reverse power flow is not possible.
Parameters for multi-phase operation including mode, number, and lead regulator.
Designates how the control operates regulators relative to each other.
Procedure to check and calibrate voltage readings.
