Eaton Cutler-Hammer MP-3000 - Page 110

Page 110 I.L. 17562
PR 0.3 Effective 8/99
P5L12 41 Antibackspin time 0-600s (0 means
OFF)
OFF,1-240 minutes
P6L1 46 Program discrete input 1 REM RST, REM
TRIP, DIF TRIP,
MTR STOP, RST
DBL
EMG OVR, ZERO
SW
P9L1
Through
P9L25
48 Trip State for AUX1 relay All trips, IOC only,
I2T only, GFLT only,
JAM only, UL only,
MBT only, LBT only,
WT only, and REV
only
Fully Programmable
- over 4,194,304
possibilities
including new load
shed function
10.7 PowerNet INCOM communications protocol - The communications messaging protocol
specification for the MP-3000 is open and available to users and communications systems
integrators without charge. Check the Cutler-Hammer Power Management Products web site
link at http:\\www.cutlerhammer.eaton.com, your Cutler-Hammer distributor, or the factory for
detailed specifications and documentation.
LED
Address
Selector
Switch
IQ Host
Device
Connection
Network
Connection
(Green Phoenix
Connector)
Function
Selector
Switch
Recommended:
18 gauge twisted pair
IMPCABLE or 20 gauge Belden 9463 class
Figure 10.1 Typical PONI Module