Page 14 I.L. 17562
PR 0.3 Effective 8/99
SECTION 4. OPERATOR PANEL
4.0 General Description — The faceplate of the MP-3000 contains the display, indicators, and
pushbuttons that make up the Operator Panel (Figures 4.1 and 4.2).
The Operator Panel is used to:
Monitor the metered values on the Display Window
Enter or modify setpoint values or settings
View motor history or statistics
View a log of recent events
Determine that a trip or alarm condition exists by means of two distinct LEDs and the cause of
the trip by means of the Display Window
Reset the unit after a trip condition has occurred by means of a Reset pushbutton
Get help on any display
Override start lockouts during emergencies
4.0.1 Display Window — All available displays are discussed in Sections 4.1 through 4.5.
4.0.2 Protected Pushbuttons — A security door located on the bottom left corner of the
operator panel covers two pushbuttons: the program pushbutton and the emergency override
pushbutton. This door will accept a lead seal to prevent unauthorized setpoint changes and the
overriding of start lockout functions.
4.0.3 Mode Pushbuttons — The four mode pushbuttons near the middle of the operator panel
provide access to the four different modes used by the MP-3000. The Monitor, View Settings,
History, and Log modes are detailed in Sections 4.2 through 4.5.
4.0.4 Navigation Pushbuttons — The six buttons with up and down arrows, located beneath
the mode buttons, are used to navigate through the modes by page, line, and value. The up
arrow buttons are used to advance through the displays, and the down arrow buttons are used to
return to the previous display. Refer to the mode examples in Sections 4.2 through 4.5 for an
explanation on the proper use of the navigation buttons.
4.0.5 Help Pushbutton — The Help pushbutton provides a scrolling explanation of the
displayed message, including units of measure, for any of the messages from the MP-3000. The
complete list of help messages for each function mode is included in Tables 4.1 through 4.5. The
help message may be terminated by pressing the Reset or Help pushbutton.
4.0.6 Reset Pushbutton — The Reset pushbutton is primarily used to reset the MP-3000 after a
trip condition. If the cause of the trip has been corrected, the displayed trip condition will be
cleared. If a trip condition is not present, pressing the Reset pushbutton to step out of Line, Page,
or Mode will bring up the Default mode displaying the status of the motor.
To Next Page
Loading...
