Eaton Cutler-Hammer PanelMate 3000 Series - Cutout Template and Mounting; Mounting and Torque Specs

Cutout Template
Care should be taken when tightening the
nuts. The fasteners must be tightened
enough to obtain a proper seal, but not over
tightened to the point where the threads are
stripped or the gasket is rendered useless.
Always use a torque wrench when installing
your PanelMate unit.
Torque Limits for Studs
7 inch-pounds for #8-32 nuts
Dimensions are in inches.
Millimeter dimensions are in parentheses.
Notes:
.22 Dia. Slot
.22 Dia. Hole
11.40
11.01
5.87
5.87
5.70
5.70
5.70
5.48
4.50
4.50
5.53
5.70
4.65
1.55
1.55
4.65
(5.59)
(5.59)
(289.56)
(279.65)
(149.10)
(149.10)
(144.78)
(144.78)
(139.19)
(114.30)
(114.30)
(140.46)
(144.78)
(118.11)
(39.37)
(39.37)
(118.11)
(144.78)
Cutout
1.50
1.50
(38.10)
(38.10)
This drawing is not 1:1 scale. Please refer to the
Express Setup Sheet included with your
PanelMate unit for a 1:1 cutout drawing.