Do you have a question about the Eaton Cutler-Hammer PanelMate 3000 Series and is the answer not in the manual?
Display Type | LCD |
---|---|
Input Voltage | 24 VDC |
Input Method | Touchscreen |
Resolution | 320 x 240 pixels |
Communication Ports | RS-232, RS-485 |
Operating Temperature | 0°C to 50°C |
Storage Temperature | -20°C to 70°C |
Enclosure Rating | NEMA 4X |
Memory | 512 KB RAM |
Carefully remove equipment, inspect for shipment damage, and retain cartons for future use.
Equipment is suitable for Class I, Division 2, Groups A,B,C,D or non-hazardous areas only.
Verifies packing carton contents, including mounting hardware, connectors, and fault relay.
Unit designed for NEMA 4, 4X, 12 enclosures. Vertical mounting is essential for longevity.
Unit operates at 24VDC. Use #18 AWG wire. Polarity reversal protection is included.
Connect to PC via serial port for firmware and configuration uploads/downloads using provided cable.
Fault relay can be normally open/closed. It de-energizes on errors, failures, or alarms.
Serial ports support RS232, RS422, RS485-2. Termination settings are crucial for communication.
Perform internal diagnostic tests and display system/configuration information.
Use Serial/Network Transfer Mode for data management; Enter Run Mode for PLC communication.
Calibrate touchscreen boundaries and adjust display contrast for optimal viewing.
Touchscreen replaces physical controls. Templates are used to arm buttons for interaction.
Use the Cleaning Mode utility for safe cleaning. Avoid solvents and foreign objects.
Calibrate touchscreen in Offline or Run modes by pressing screen indicators sequentially.
Provides cutout dimensions, torque limits for #8-32 studs, and cautions for secure mounting.
Covers operating temperature, humidity, NEMA class, altitude, and electrical immunity standards.
Details voltage, power consumption, current draw, and peak inrush current for unit operation.
Provides contact details for technical assistance, including phone, fax, website, and email.