11INSTALLATION AND OPERATION MANUAL 25-17603-C March 2023 www.eaton.com
4. Programming Sensitivity and Span
4. Programming Sensitivity and Span
Before using the detector, the operation range and sensitivity should be set
according to the application environment. The sensitivity and span of the detector
can be set using the DIP switches. Use DIP switch (SW2) to set the parameter set
you want (see table below).
Sensitivity
Level 1
Span
Span 1: 8~20m
Span 2: 20~40m
Span 3: 40~70m
Span 4: 70~100m
Level 2 Level 3
5. Commissioning Beam Detector
Figure 8. Names and Location
To Next Page
Loading...
