Eaton ePDU G3 Installation And Connection Guide

INSTALLATION
INSTALLATION
Eaton
®
ePDU
®
G3
Environmental Monitoring Probe (EMP) Installation and Connection Quick Start
English
www.eaton.com/ePDUG3
3
1
2
1
2
1
2
Never turn on any equipment when there is evidence of fire, water, or structural damage.
An EMP can be installed without turning off power to the ePDU or the devices connected to it.
You can install the EMP either before or after ePDU installation and startup.
Read and understand the operator's manual before using this equipment.
- or -
EMP001 Connection Cable
Tie Wraps
Screw
Screw Anchor
Velcro Fastener

Eaton ePDU G3 Specifications

General

Category	Power distribution unit
Form Factor	Rack-mountable
Network Management	Yes
Monitoring	Yes
Remote Management	Yes
Metering	Yes
Input Frequency	50/60 Hz
Output Receptacles	IEC C13, IEC C19
Switching	Yes
Phase	Single-phase
Outlet Type	IEC C13, IEC C19
Communication	Ethernet, Serial
Maximum Current	32A
Operating Temperature	0°C to 40°C
Operating Humidity	5% to 95% non-condensing
Model	Eaton ePDU G3