Need help?Do you have a question about the Eaton ePDU G3 and is the answer not in the manual?
General| Category | Power distribution unit |
|---|---|
| Form Factor | Rack-mountable |
| Network Management | Yes |
| Monitoring | Yes |
| Remote Management | Yes |
| Metering | Yes |
| Input Frequency | 50/60 Hz |
| Output Receptacles | IEC C13, IEC C19 |
| Switching | Yes |
| Phase | Single-phase |
| Outlet Type | IEC C13, IEC C19 |
| Communication | Ethernet, Serial |
| Maximum Current | 32A |
| Operating Temperature | 0°C to 40°C |
| Operating Humidity | 5% to 95% non-condensing |
| Model | Eaton ePDU G3 |
Information on product specs, diagrams, part numbers, and ordering available at www.eaton.com/ePDU.
Description of the LCD interface, operated via display, buttons, and the eNMC module.
Explanation of circuit breaker function for outlet sections exceeding load ratings.
Information on various outlet types available for ePDU models, standard or customized.
Highlights benefits like ease of use, communication, power control, monitoring, and security.
Covers configurable alarm thresholds, user access control, and enterprise security options.
Manual provides crucial instructions for safe installation and operation of the ePDU G3.
Highlights hazardous voltages, authorized service personnel requirements, and environmental precautions.
Pre-installation checks, handling precautions, and power outlet requirements.
Details on mounting ePDU G3 without tools and vertical/horizontal configurations.
Describes three methods for installing ePDUs vertically in rack cabinets.
Instructions for installing the ePDU using mounting buttons attached to clip feet.
Steps for installing the ePDU using clip feet secured by cage nuts in square-hole racks.
Guidance on installing horizontal ePDU models within rack cabinets.
Overview of ePDU ports for network connectivity and environmental monitoring.
Steps for connecting devices like workstations and servers to ePDU outlets.
Refers to the Operation Overview section for starting and shutting down the ePDU.
Describes local (LCD) and remote (network) interfaces for ePDU control.
Details the ePDU's LCD display and its information presentation.
Lists available remote interfaces: Web browser, SNMP, and CLI.
Describes outlet types, grouping into sections, and associated circuit breakers.
Instructions for upgrading the eNMC module firmware via USB flash disk.
Details the process of upgrading firmware using the HTTP protocol via Web interface.
Details the two stages of firmware upgrade using the FTP protocol.
Covers firmware upgrade via USB and provides an overview of active alarms.
Details the steps for upgrading firmware using the HTTP protocol.
Steps to upload the firmware binary file via HTTP for upgrade.
Describes the process of upgrading and refreshing Web pages post-HTTP upload.
Details the steps for upgrading firmware using the FTP protocol.
Steps to upload the firmware binary file via FTP for upgrade.
Describes the process of upgrading and refreshing Web pages post-FTP upload.
Provides instructions for upgrading firmware using the USB port.
Details the limited warranty terms for Eaton ePDUs in USA and Canada.
Covers warranty coverage, periods, and procedures for repair or replacement.
Outlines procedures for repairing or replacing standard and custom ePDU products.
Lists conditions not covered by warranty and limitations of liability.
Details End-user obligations and other warranty limitations.
Specifies costs not covered by the warranty, such as site calls for inspections.
Provides contact information for obtaining warranty service and support.
To Next Page
