Installation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 19
Figure 16. Securing the ePDU
Using Mounting Buttons Installed on Clip Feet
To install the ePDU with mounting buttons installed on the mounting clip feet:
1. Locate the two mounting clip feet, M6 flathead screws, two spare plastic mounting buttons, and
mounting hardware (M4 screws and M4 hex nuts). Using a Phillips screwdriver, assemble the mounting
buttons and clip feet (see Figure 17).
Figure 17. Attaching the Mounting Buttons to the Mounting Clip Feet
To Next Page
Loading...
