Eaton ePDU G3 - Operation Modes and Startup Screen

LCD Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 43
Operation Mode
Screensaver Cycling Sequence
The screensaver displays automatically after 30 seconds of inactivity from the start-up screen, a menu, or a
submenu. Values are reset every five seconds.The screensaver displays data in a preset 1Ph cycle (Figure 38)
or 3Ph cycle (Figure 39). These cycles are not user-configurable.
14.8
Amp
Total Input
5 s
5 s
14/06/2013
15:55:26
192.168.123.123
P/N
Figure 38. 1Ph Screensaver Cycle
5 s
5 s
5 s
5 s
8.61
Amp
Phase 1
1.47
Amp
Phase 3
3.26
Amp
Phase 2
14/06/2013
15:55:26
192.168.123.123
P/N
Figure 39. 3Ph Delta-configured Screensaver Cycle
Startup Screen
When the ePDU powers up, the Startup screen displays (see Figure 40). Press ENTER to go to the Main Menu.
14/06/2013
15:55:26
192.168.123.123
P/N
Figure 40. Startup Screen