Web Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 115
4. To select and store an eNMC module configuration file to be used during an upgrade, use Browse to
review and select the configuration file.
NOTE When uploading a file, you cannot write the file path in the text field. You must
select the file from the file explorer window that displays when you click Browse.
5. Click either Upload or Download Configuration and a message is provided to tell you if the file uploaded
successfully or failed to upload:
l
Upload: Gets the list of the ePDU XML parameters from a file selected by the browser and sends it to
the ePDU.
l
Download Configuration: Stores a list of the ePDU XML parameters in a file selected by the browser.
6. To restore the eNMC module to factory defaults, click Rest
ore Factory to default settings. A pop-up
confirmation message displays:
Are you sure you want to restore the factory default settings of the Network
Man
agement Card?
Note: This will NOT restart the ePDU or change the power status of the outlets.
Perform Firmware Upgrade
NOTE A firmware upgrade can only be performed by a SuperUser. This upgrades the
firmware and the Web page. The Web interface will not be available during the
upgrade.
1. Access the Web interface and log in.
2. Under Settings, select System. The System Settings page displays.
3. In the Network Management Card panel, ensure the firmw
are upgrade functionality is enabled and that
the upgrade file has been downloaded.
4. To upgrade the communications module, click Up
grade network management card. The upgrade is
launched immediately.
5. Click Restar
t network management card.
6. When the upload of the image file completes, t
he following message displays:
Your file was correctly uploaded.
Please wait about three minutes while the image writes to your flash device,
the
n click the browser refresh button.
Click OK to restart the card and begin the upgrade of the firmware.
ePDU Configuration
1. Access the Web interface and log in.
2. Under Settings, select System. The System Settings page displays.
3. Ensure that the Device Administrator Contact Name and the Device location have been typed in the text
boxes.
To Next Page
Loading...
