LCD Interface Operation
Eaton ePDU G3 Operation Manual P-164000277—Rev 1 www.eaton.com/ePDU 55
Upgrade the eNMC Module Firmware
To upgrade the eNMC module firmware:
1. Connect a USB flash disk to your computer and put th
e Image*.bin file on the flash disk in the eNMC/
upgrade/ location.(see Figure 59).
Figure 59. Root of Flash Disk
2. Make sure eNMC module is powered ON.
3. Insert the flash drive in the USB port of the eNMC front panel.
4. When the pop-up confirms that the USB is detected, click OK then press Enter to return to the Main
Menu. (If not confirmed within 10 sec, the USB flash disk is ignored by eNMC module.
5. Select USB Flash Mode. Click Ye s to confirm you want to enter the USB Flash mode. (If there is no action
within one minute, the eNMC module exits the USB Flash mode. Unplug and replug the USB flash disk to
access this menu
again.) The module restarts.
6. Select Upgrade FW and click OK to confirm the upgrade. The eNMC module gets the file from the USB
flash disk.
7. A few seconds after 100% is reached, the eNMC module restarts and then enters in Boot upgrade mode
to contin
ue upgrade. The upgrade is finished when eNMC module is restarted. This can take several
minutes (see Figure 60).
ESC
Enter
USB Upgrade F/W
Current Vers.
00.00.0021
Main Menu
USB Upgrade F/W
Current F/W
version.
00.00.0021
Upload
45 %
ESC
Enter
Load Config.
Save eNMC file
Load eNMC file
Exit
USB Flash Mode
Save Config
.
Upgrade F/W
Figure 60. Example Upgrade
Exit
Select Exit to leave USB Flash Mode.
Display Submenu
The Display submenu allows you to customize settings for LCD contrast and orientation (see Figure 61).
On the Settings menu, scroll up or down to highlight DISPLA
Y. Press ENTER to display the screens to set the
values for the submenu. After you select the values, press ENTER to set the values as displayed on the screen.
Press ESC to return to the previous menu.
To Next Page
Loading...
